Happy New Year!

Posted on

The countdown is on, Thursday Crafthackers!

If you’re throwing a New Year’s Eve party, then you are in countdown mode (literally) for figuring out food, outfit and of course, decorations!  I’ve got one for a photobooth backdrop that is super impressive and really festive!

The first is from Oh Happy Day (the original post can be found here). The only thing that you will need to get ahold of is large sequins, which might be a little challenge to find but they can certainly be ordered here or here, or you can check the craft stores near you to see what they have available. You can use any size, but the larger they are, the less you need, the less time consuming. At 60mm, you will need about 600 of them.  You will also need 6 pieces of thin foam board at 1/8″ thick, and 32″ x 40″ wide. 2 rolls of cheap gold or silver wrapping paper to cover the board, good masking tape (that comes off the walls without tearing the paint), 600+ sequin pins (really short straight pins, one for every sequin), a ruler and a long piece of posterboard to make a guide.

Your first step is to attach the foam board. Tape it to the wall, so that we can have an undamaged wall after this project. Stack them from the floor up so that the weight is on the floor and the tape just holds them in place.

Next, tape the wrapping paper on top of the foam board. Don’t worry about the seams, when the sequins are added, you can’t really see them.

Next, add your first row of sequins, starting at the bottom of the wall. You don’t have to start at the very bottom, just below where your camera will capture. Figure out how far apart you’d like the sequins. This tutorial used 2.5″ between each pin, and, to get it straight, use a ruler :).

For the second row of sequins, you can test out how you like the spacing. They look nice when they’re staggered, so they nestle between each other.

 

You can now make a guide so that you only really need to measure those first two rows Use a long piece of poster board the exact distance between the first and second row of pins. Using a ruler, make a pencil mark every 2.5″ on one side of the guide. Make a few marks on the other side to line up to the pins that are already in place.

Your next step is to pin them all up! When you have your guide, you can place it on top of the second row of pins and you will know exactly where to stick your pins into the board. It’s good to try to be accurate but it will get easier once you get going. The sequins cover up many flaws. Just try to make sure that they are parallel with the floor, that way they won’t sit against the wall, they’ll dangle and sparkle and move when people walk by. Hanging it towards the front of the pin will give you maximum shine!

Hope everyone has a safe and happy New Years!

~ Megan

 


Leave a Reply