DIY: Concrete Lamps

Posted on

Good morning Thursday Crafthackers,

Last week we looked at making vases out of concrete. Today, with a tutorial from Brit + Co we will be looking at using concrete again, and using them to make some stylish hanging lamps. You will be able to find the full tutorial here, should you need some more info.

I love that these projects have minimal materials cost and are pretty stylish and sleek. They also recycle some garbage and use it to make these awesome things! Most of the materials are fairly inexpensive and available at most hardware stores. The original poster used Quikrete 5000 concrete mix, an electrical socket, switch and cord, two plastic bottles (one larger and one smaller – think 2 liter and 1 liter… something along those lines), a threaded tube and nuts (3/8th inch diameter tube), 3 1/2 inch deck screw, 120 grit sandpaper and a metal can. Your tools are also pretty simple. A box cutter or knife, a cordless drill with 3/8th diameter standard bit for drilling holes into the caps, wire cutters to cut the cord and strip wires.

First, poke a hole in the soda bottle with a box cutter and use scissors to cut off the bottom of the bottle. Next, drill a hole in the caps of both bottles, which is made significantly easier by keeping the cap on the bottle. The hole should be just big enough to screw the metal tube through.

To connect the bottle caps together, screw the tube through both caps and use nuts on either side of each cap to hold them in place.

Screw both bottles into their caps.

Use the desk screws to keep the bottles stabilized.

Mix the concrete to the manufacturer’s directions and fill the mold. It might be easier to use a spoon to get it in there rather than pouring. Shake and tap the mold after each spoon to make sure everything settles without air bubbles. Use the metal can to stabilize your mold.

After you’ve given the concrete time to dry – I would say at least a couple days, but again, follow the manufacturer’s directions, then it’s time to remove the bottles. You can cut the external bottle away using a box cutter and scissors. With a hair drier you can heat the internal bottle to make it a little softer so you can pull it out with pliers. Sand any rough edges.

Cut the socket end of the wire and thread the cut end through the bolt hole. Strip the wires and twist them together. Cover the exposed metal with electrical tape or wire nuts and make sure the pendant is securely fastened. You can find brackets from furnishing stores with which to hang and the one in this tutorial came from Ikea.

You can mix concrete colours, use different bottles and even changeĀ  the way you pour the concrete to get some different and really cool effects.

 

Happy crafting!

~ Megan


Leave a Reply