DIY Casette Tape Wallet

Posted on

Good morning Thursday Crafthackers!

This morning, I have a lovely DIY tutorial that works those retro stylings with a cassette tape wallet. Now, I know there are those of you around who have never seen a cassette tape in real life before but they do still exist! Raid your parent’s basements or you can find them at second hand stores or used music stores pretty easily.  By the way, I took this tutorial from Wonderful DIY and you can check out the original here.

Your tools are pretty simple: You’ll need glue (E600 is excellent as it will work on porous and non porous materials), and a screwdriver. You’ll also need some materials: a fabric zipper, scrap fabric, a disposable plate for mixing epoxy and a wooden stir stick, if you’re using a glue that is an epoxy.

Next, you’ll need to open your tape. If your cassette is screwed together, you can use the screwdriver to loosen the screws so the tape will come apart. If they’re welded with fasteners, gently pry the sides apart until the fasteners break. Be gentle and it should come apart just fine.

Empty the cassette of the tape and any other bits, and make sure that you take off anything extra with pliers or a box cutter. You basically just want the shell.

Measure your zipper. It should be the same length as three sides (the bottom long edge will basically be the hinge). Trim the zipper at the right length and sew the end so it doesn’t come off where you cut it. Glue the zipper around the edge of each side of the cassette.

Open the zipper, and start at one side and then the other, apply glue around the inside edges of the plastic and carefully press the outer fabric of the zipper into it. Make sure the side of the zipper with the pull is facing outwards so you can open and close your wallet when it’s done. Let everything dry.

Along the edge of the cassette that doesn’t have zipper attached to it, create a fabric pouch. This will help the wallet open and close. Unzip the wallet and lay the sides open and flat so the unglued sides lay parallel. To do this, measure a rectangle of fabric as long as the middle side. The strip should be about as thick as the zipper when it’s zipped. glue the pouch fabric in place and let it dry.

Cover the holes in the sides of the cassette by gluing paper or fabric over them. Cover the insides of the wallet. You can use graphic fabric or the paper booklet that came with your cassette. Let it dry. Test it, and make sure the zipper works.

Now you have a totally awesome retro wallet that you can reminisce about the good times with your friends when you pull it out of your back pocket.

Happy crafting!

~Megan


Leave a Reply