Good morning Thursday Crafthackers!
I have a lovely tutorial today brought to you by Shanty 2 Chic that transforms frames into fabulous little shelves where you can display anything from books to collectables. You can find the whole tutorial here, but I’ll give you the basic rundown with some photos from both this website and others to give you some inspiration.
Your first task is to assemble what you need to make this business happen! First you will need your frames. You can decorate old ones you have lying around, buy cheap ones at a garage sale or second hand store to dress up, or buy new ones that you can dress up or leave bare, whatever you prefer! And of course the number you make is up to you. With your frames, you’ll need to remove the glass, the backing and any hardware that is attached to the frame itself.
Your next step is to measure your frames – measure the inside of the frame and cut the wood (1 inch by 4 inch cut to your measurements). You can use scrap boards, as long as you have the means to cut it, and it doesn’t really matter the type of wood. If you don’t have the means to cut it, many hardware stores that sell unfinished wood will help you with this. Make two cuts for each side (as pictured above). Keep in mind that you do not need to have the boards set inside the lip where the glass used to sit. Just keep it a little bit bigger than that edge so that you have a little room for error and a little breathing room so we don’t give ourselves anxiety attacks over worrying about millimeters.
Next you will need to build your square. This tutorial recommends first gluing all the sides together with Gorilla Glue or wood glue, and then nailing them together either with a nailgun or just a good old fashioned hammer.
You should end up with a frame like this (pictured above), that is smaller than your actual frame.
This poster uses the same process of first gluing the picture frame to the crafted frame and then using 1 1/4 inch brad nails, they nailed through the front of the frame to hold onto the back securely.
You have a couple small last steps before you can display your marvelous DIY for all the world to see. First you’ll need to get a little tube of hole filler (found at your local hardware store) to fill the little holes left by the nails. And after that is dry, it’s time to paint your frame! You can use a spray paint to do it all one colour, whether it’s metallic or neon pink or just a plain, sophisticated white, or you can crack out your artist’s palate and paint them all individually by hand in whatever artistic way you can imagine.
Your last step is to hang them on the wall. Just be sure to buy some picture hanging supplies so that you don’t do any undue damage to your walls, especially if you’re going to be putting anything heavy on your shelves. If you’re not going to be putting anything too heavy inside, you can use these types of picture hanging supplies (one on each side) to hold your frame up and these types of no hole hanging supplies can be found at hardware stores. If you’re going to be putting something heavier on your shelves, I fully recommend heavier hardware.
I hope that this was an inspiring little DIY. I think it’s a fantastic alternative to bookshelves or whole shelving units that looks a whole bunch more unique and amazing.